hello, what should I do with “ERROR: write_particle: Failed to write FLOAT phsp data” when using beamdp_gui to…

EGSnrc: Discussion 1 Minute

hello, what should I do with “ERROR: write_particle: Failed to write FLOAT phsp data” when using beamdp_gui to combine two ph-ap files into one?

thanks a lot!

Unknown's avatar

Published by rtownson

Published

2 thoughts on “hello, what should I do with “ERROR: write_particle: Failed to write FLOAT phsp data” when using beamdp_gui to…”

  1. It’s likely that one of the phase-spaces is corrupt. Did you download them from a website? If so it’s a very common problem. You might need to download again, and consider checking filesizes or checksum.

    Like

    Reply

Leave a comment